Search results for: “”

  • Taftbond HM105NF

    Taftbond HM105NF is a specialist non-flammable contact adhesive for worksites where conventional solvent adhesives pose a fire risk. It is purpose-built for tunnelling, where EPDM gaskets are bonded to precast concrete segments, and its non-flammable performance is independently verified by SETSCO.

  • Taftbond HM232ST

    Taftbond HM232ST is a general-purpose clear contact adhesive that dries quickly to a firm bond by brush or roller. Its transparent finish suits discreet bond lines, it is safe on Styrofoam, and it resists heat, aging, water, detergents, oils and grease.

  • Taftbond HM969G

    Taftbond HM969G is a green, neoprene-based spray-grade contact adhesive for fast, even coverage over large and complex surfaces. It bonds stainless steel, natural rubber, most plastics, wood, rock wool, veneers and PU foams, with good heat, aging and water resistance.

  • Taftbond Solid Surface Adhesive

    Taftbond Solid Surface Adhesive is a two-component, toughened structural methacrylate made for the solid surface industry. It is colour matched to granite, marble, engineered stone, quartz and solid surface materials, and cures fast at room temperature to a high-strength, invisible seam.

  • Krystal 5000

    Krystal 5000 is an ultra-low-viscosity UV adhesive for bonding glass to glass and glass to stainless steel. It is colourless and transparent in thin films, so edge bonding between glass stays seamless.

  • Krystal 4000

    Krystal 4000 is a low-viscosity UV adhesive that cures in seconds under ultraviolet (365nm) or visible (436nm) light. Its high permeability suits glass face-to-face and T-type bonding, and it can be applied by penetration for a clean edge glue line.

  • Taftbond 5 Minutes Epoxy

    Taftbond is a two-part, five-minute epoxy that mixes 1:1 by volume or weight and cures to a tough, transparent bond. It sets in about five minutes, and bonded parts can be put to use in under fifteen minutes, with minimal shrinkage and no whitening once set. Taftbond bonds metal, wood, glass, fibreglass, composites and most…

  • Request a Sample

  • Substrate selector

  • Methacrylate or epoxy: choosing a structural adhesive for metal

    Methacrylate and epoxy both bond metal under load. Methacrylate is tougher and surface tolerant; epoxy is more rigid and chemical resistant.