DIY 的粘接解决方案。

Krystal 2000 cures under UV light at 365 nm or visible light at 436 nm, while Krystal 3000 cures under UV or visible light. For Krystal 2000, strong direct daylight through a window may be enough to start cure on a thin, clear joint, but a dedicated 365 nm UV lamp gives faster and more consistent results. Indoor ambient light alone is generally not sufficient. Check the product TDS for the minimum light intensity and cure time. Gluing restores appearance, not strength: replace cracked safety glass, such as a shower screen or glass door, rather than repairing it.

AFT 1080GF is rated for structural double-sided bonding on metal, aluminium, stainless steel, acrylic, and glass, with a 180-degree peel strength of 3000 g/25mm. Load capacity depends on the substrate, surface area bonded, and how the load is applied. Painted drywall is a softer substrate than the materials listed in its ratings. Clean the surface thoroughly before applying the tape and check the TDS for substrate compatibility before committing to a no-drill installation. It suits hooks, trim strips and light fittings on clean, smooth surfaces; no MightyLoc document gives a load figure for a shelf, so do not hang a shelf on the tape alone.

Taftflex 6221 是一款单组分聚氨酯密封胶兼胶粘剂，永久保持弹性，可涂漆，使用温度范围为 -40 至 +80 C。对于位移量更大的接缝，Taftflex 6292 的断裂伸长率约为 600%，同样可涂漆、不污染基材，在大气湿气条件下固化速率约为每 24 小时 3 mm。请查阅 TDS，了解针对具体基材的推荐接缝宽度和表面处理要求。

The Taftspray 78 technical data sheet lists lightweight foams among its bonding substrates. Solvent-based adhesives can dissolve or distort polystyrene foam, so ask MightyLoc before spraying it onto polystyrene foam board. Use it in a ventilated space. Check the TDS for recommended application distance, drying time, and coverage guidance before starting a large lamination job.

Krystal 2000 的使用温度范围为 -40 至 +120 C，Krystal 3000 为 -40 至 +100 C。东南亚地区正常室内及有遮蔽的室外环境温度均在上述范围之内。若粘接部件将长期承受超过上述温度上限的直接热源（如靠近炉灶或处于工业热源直接辐射区域），请查阅 TDS，并评估是否需要选用其他化学体系的胶粘剂。